-Exceeds NFPA-1901 standards
-Gives an LED effect
-Warns oncoming traffic and keeps
 your firefighters safe.
-Brightest reflective material available
-Customization available
 (full color logos, lettering)
-Very easy to install yourself

If you would like to order 911 Dots these are the steps:

Step 1 - With a digital camera, take pictures of the rear of each apparatus you are looking to have retro-fitted with chevron striping. Do your best to take the picture as square as possible.

Step 2 – Measure either the entire rear end, or a specific area in the picture such as a door, a bumper, or any square area on the rear of the vehicle. This measurement is used to scale your pictures in our software to actual size to ensure that the chevron panels will fit properly.

Step 3 - Email us at sales@911depot.ca with the pictures, measurements and ideas. We will then proceed to make up some proofs and get them back to you for approval.

911 Dots are made from Reflexite micro prismatic reflective materials.